1、在清洗之前，首先检查油脂保有盆的情况，用以确定和判断现行加油、补油制度的有效性。其次检查油脂的理化状态，看有无发千、变硬、结块，析油、稀化、变色等变质情况，用以确定和判断油脂老化更换周期的合理性，调整换油周期和补油制度。
1, before the cleaning, first check the oil retention basins, to determine and to determine the effectiveness of the existing fuel, fill the oil system. Secondly checking physical and chemical state of the grease, see with no Millennium, harden, clots, analysis of deteriorating situations such as oil, thinning, discoloration, to determine and to determine the reasonableness of aging oil replacement cycle, adjusting the cycle and fill oil oil change system.
2.深沟球轴承清洗是恢复深沟球轴承清洁度和进行深沟球轴承零件检查测量的必要环节。清洗前要尽量抹去旧的脏污油脂，操作过程中注意不要随意转动深沟球轴承，以免解体过程中进人的杂质拉伤滚动工作面;搬动深沟球轴承时要轻拿轻放，防止碰伤。
清洗工作一般是在柴油池内进行，柴油加热到80--90t,经油泵加压，循环冲洗深沟球轴承。请洗池下部要有金属网，防止深沟球轴承落入池内的沉殿物中。池内的柴油要定期过滤，补充新油，清理沉殿物，以保持柴油达到工艺规定的清洁度。
Cleaning work is generally done within the diesel pool, heating diesel to 80--90t, pump pressure, circulating flush of deep groove ball bearings. Please wash pond lower with metal mesh to prevent falling into the pool of deep groove ball bearing sinking in the temple. Diesel regularly within the pool filter, new oil, clean up the sinking Palace to keep diesel meet technology of cleanliness.
清洗液禁止采用带混蚀性的介质。传统的冲洗或高温(以蒸汽与水的混合液喷洗，温度略超过油脂的滴点)清洗工艺，只要能满足清洗质量要求，也不必刻意求新。
Corrosion cleaning liquid ban the use of mixed media. Traditional flush or high temperatures (a mixture of steam and water spraying, the temperature slightly in excess of grease drop points) cleaning process, as long as they can meet the cleaning quality requirements, do not have to deliberately innovation.
本文来源http://www.beier-bearingshop.com
公司新闻